Volume 5, Issue 1, January 2016, Page: 31-35
Experimental Study on Fracture Behaviors of Concrete Beams Strengthened with FRP Sheet of Different Width
Juanxia Zhang, School of Mechanics and Civil Engineering, China University of Mining and Technology, Beijing, China; College of Resources and Civil Engineering, Northeastern University, Shenyang, China
Zhonghui Chen, School of Mechanics and Civil Engineering, China University of Mining and Technology, Beijing, China
Xianzhang Guo, College of Resources and Civil Engineering, Northeastern University, Shenyang, China
Wencheng Ma, College of Resources and Civil Engineering, Northeastern University, Shenyang, China
Received: Jan. 31, 2016;       Accepted: Feb. 15, 2016;       Published: Feb. 26, 2016
DOI: 10.11648/j.ijmsa.20160501.15      View  4514      Downloads  144
Abstract
A total of six beams have been tested to investigate the influence of FRP sheet on the mechanical behavior of concrete beam with different FRP sheet width. In addition, the failure mode of the concrete beam and FRP reinforced concrete beams were also studied by numerical simulation method named Realistic Failure Process Analysis (RFPA). The results indicate that, the loading capacity is increased and maximum deflection of the concrete beam is also increased with the increasing of the FRP sheet width. Moreover, the interfacial debonding easily propagates along the interfacial concrete layer at a load that is below the estimated maximum strength of the FRP-strengthened structure. The maximum strength of the FRP sheet in the experiment was not achieved due to the adhesive layer between the concrete and FRP sheet was not strong enough compared with the numerical simulation result. It showed that the FRP sheet width was considered to be an important factor influence the failure mode and load capacity. So does the interface between the concrete and FRP plate.
Keywords
Experiments, Concrete Cracks, Failure Mode
To cite this article
Juanxia Zhang, Zhonghui Chen, Xianzhang Guo, Wencheng Ma, Experimental Study on Fracture Behaviors of Concrete Beams Strengthened with FRP Sheet of Different Width, International Journal of Materials Science and Applications. Vol. 5, No. 1, 2016, pp. 31-35. doi: 10.11648/j.ijmsa.20160501.15
Copyright
Copyright © 2016 Authors retain the copyright of this article.
This article is an open access article distributed under the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0/) which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Reference
[1]
G.B. Maranan, A.C. Manalo, B. Benmokrane, W. Karunasena, P. Mendis. Evaluation of the flexural strength and serviceability of geopolymer concrete beams reinforced with glass-fibre-reinforced polymer (GFRP) bars. Engineering Structures. 2015, 101(15):529-541.
[2]
R Z. Al-Zaid, A.Z I. Al-Negheimish, M. A. Al-Saawani, A. K. El-Sayed. Analytical study on RC beams strengthened for flexure with externally bonded FRP reinforcement. Composites: Part B, 2012, 43(2): 129-141.
[3]
G.M. Chen, J.G. Teng, J.F. Chen, Q.G. Xiao. Finite element modeling of debonding failures in FRP-strengthened beams: A dynamic approach. Computers and Structures, 2015, 158:167-183.
[4]
F. Taheri, K. Shahin, I. Widiarsa. On the parameters influencing the performance of reinforced concrete beams strengthened with FRP plates. Composite structures 2002, 58(2):217-226.
[5]
M’hamed Berrezoug Zidani, Khalil Belakhdar, Abdelouahed Tounsi, EI Abbes Adda Bedia. Finite element analysis of initially damaged beams repaired with FRP plates. Composite Structures, 2015, 134:429-439.
[6]
Xin Wang, Jianzhe Shi, Gang Wu, Long Yang, Zhishen Wu. Effectiveness of basalt FRP tendons for strengthening of RC beams through the external prestressing technique. Engineering Structures.2015, 101:34-44.
[7]
M.S. Mohamed Ali, Deric J. Oehlers, Sung-Moo Park. Comparison between FRP and steel plating of reinforced concrete beams, Composites: Part A, 20013, 2:1319-1328.
[8]
T. Rabczuk, J. Akkermann, J. Eibl. A numerical model for reinforced concrete structures. International Journal of solids and structures.2005, 42(5-6):1327-1354.
[9]
M’hamed Berrezoug Zidani, Khalil Belakhdar, Abdelouahed Tounsi, EI Abbes Adda Bedia. Finite element analysis of initially damaged beams repaired with FRP plates. Composite structures, 2015, 134:429-439.
[10]
Rui Sun, Enrique Sevillano, Ricardo Perera. Debonding detection of FRP strengthened concrete beams by using impedance measurements and an ensemble PSO adaptive spectral model. Composite Structures. 2015, 25:374-387.
[11]
J.G. Teng, S.S Zhang, J.F. Chen. Strength model for end conver separation failure in RC beams strengthened with near-surface mounted (NSM) FRP strips. Engineering Structures, 2016, 110:222-232.
[12]
Mario R.F. Coelho, Jose M. Sena-Cruz, Lus A.C. Neves. A review on the bond behavior of FRP NSM systems in concrete. Construction and Building Materials, 2015, 93:1157-1169.
[13]
J. X Zhang, W.C Zhu, C.A Tang, X. Z Guo. Influence of FRP sheet length on failue process of reinforced concrete beam. Journal of Northeastern University (Natural Science). 2011, 32 (10):1495-1498.
[14]
J.X Zhang, C.A Tang, W.C Zhu, Z.Z Liang, et al. Numerical simulation of fracturing behaviors of FRP-strengthened concrete members. Engineering mechanics, 2006, 23(12): 143-147.
[15]
T. Xu, Z.J He, C.A. Tang, W.C. Zhu, P.G. Ranjith. Finite element analysis of width effect in interface debonding of FRP plate bonded to concrete. Finite elements in analysis and design.2015, 93:30-41.
[16]
J.X. Zhang, Numerical investigation on failure mechanism of concrete structures. Doctorthesis, Shenyang, 2006.
[17]
C.A Tang, W.C Zhu, Damage and fracture of concrete. Science Press, Beijing, China, 2003.
Browse journals by subject